SatFinder digital Digisat III Pro LCD
Profesional Buscador de satélites
Satellite Tracking Meter
The Digisat III is designed to be an aid in aligning satellite antennas so that they can provide maximum performance. Please be aware of the fact that there are numerous satellites which will cause the Digisat III to respond with a signal reading. The installer must select the correct satellite for alignment. It is quite easy to select the wrong satellite and find that the satellite receiver indicates "No Signal". The software provided with the satellite receiver can provide the elevation and azimuth of the satellite desired. With this information in-hand and a good compass you can point the antenna in the proper direction.
Then, with the aid of the Digisat III , the performance of the antenna can be maximized by watching the tuning bar and digital strength readings. Please take time to read this instruction manual so you will be familiar with the capabilities of the Digisat III.
Input Frequency: 900-2200 MHz
Input Level: 20-100 dByV
Through Loss: 3.5 db
Input impedance: 75 Ohm - "F" connector
Output Impedance: 75 Ohm - "F" connector
Measuring Method: LCD display with full text graphics.Pitch tone on audio speaker
Power Supply: From receiver through coaxial cable or Optional external 12-18 vDC battery with center pin positive (+)
Power Consumption: 40 mA
Overload Protection: 50 mA utilizing audio speaker 800mA LNBF current draw limiter (Meter indicates "Over Current")
Input Voltage Tolerance: Battery up to +18vDC max. Receiver up to + 28vDC max.